Variable refrigerant flow systems (VRF)

A variable refrigerant flow system connects multiple indoor units to shared outdoor equipment. Each zone can adjust its heating or cooling output.

Where it fits

VRF can suit a retrofit where several rooms need individual temperature control and space for large supply ducts is limited. Refrigerant pipes link the indoor units, so the pipe routes, outdoor unit location and plan for bringing outdoor air into each occupied room all matter.

  • Multi-tenant offices with differing hours and room loads
  • Hotels or other buildings with many independently controlled zones
  • Renovations where central duct space is limited and ventilation can be routed separately

How it works

  1. Respond to calls from each room

    Each indoor fan coil circulates room air. Refrigerant flow at the indoor unit changes with the zone demand, and the outdoor unit adjusts compressor capacity as the combined demand changes.

  2. Select the heating and cooling arrangement

    On a common heat-pump circuit, indoor units generally operate in the same mode. A heat-recovery arrangement can serve zones needing opposite modes at the same time by transferring heat between them.

  3. Coordinate outdoor air and winter operation

    In a common arrangement, a dedicated outdoor-air unit delivers ventilation to the occupied rooms. For an air-source system, the outdoor design temperature affects the heating capacity available and the need for supplemental heat.

Planning a project

  • Send the room layout, occupancy hours and the zones likely to need simultaneous heating and cooling.
  • Identify possible outdoor unit locations, pipe routes and elevation changes. Mark how outdoor air and exhaust reach the spaces today.
  • Provide the building location, existing heat source and rooms that must remain heated during defrost or service.

Related systems

Technical references

Discuss this system with Ponka

Tell us about the building, the spaces it serves and how they are used.

Discuss your project